Canister Purge Solenoid: Service and Repair
Purge Control Solenoid ValveREMOVAL
1. Remove the collector cover.
NOTE: Follow the steps below when removing the collector cover.
1. Pull up the two points at the rear (A).
2. Pull up the two points at the front (B) while moving them forward.
2. Disconnect the ground cable from battery.
3. Loosen the clamp (A) which connects the air intake boot assembly.
4. Loosen the bolt (B) which secures the air intake boot assembly to the collector cover bracket.
5. Remove the air intake boot assembly, and move it to the left side wheel apron.
6. Disconnect the connector and hoses of purge control solenoid valve, and then remove the purge control solenoid valve.
INSTALLATION
Install in the reverse order of removal.
Tightening torque: 19 N.m (1.9 kgf-m, 14.0 ft-lb)
Tightening torque:
Clamp (A) 3 N.m (0.3 kgf-m, 2.2 ft-lb)
Bolt (B) 6.5 N.m (0.7 kgf-m, 4.8 ft-lb)
