Oil Pump: Service and Repair
Scavenge PumpREMOVAL
CAUTION:
If engine oil is spilt onto the exhaust pipe, wipe it off with cloth to avoid emission of smoke or causing a fire.
NOTE:
The scavenge pump is installed on turbo models.
1) Lift up the vehicle.
2) Remove the under cover.
3) Remove the union bolt (A) which fixes the oil pipe (C) to the scavenge pump (E).
4) Remove the bolt (D) which fixes the scavenge pump (E) to the cylinder head, and remove the scavenge pump using a flat tip screwdriver.
CAUTION:
Be careful not to damage the mating surfaces of the cylinder head and scavenge pump.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
Do not start applying liquid gasket from (A) as shown in the following figure.
NOTE:
^ Use a new gasket.
^ Install within 5 min. after applying liquid gasket.
Liquid gasket:
THREE BOND 1217G (Part No. K0877Y0100) or equivalent
Tightening torque:
T1: 6.4 Nm (0.7 kgf-m, 4.7 ft-lb)
T2: 29 Nm (3.0 kgf-m, 21.4 ft-lb)
INSPECTION
1) Check that the scavenge pump and oil pipe have no deformation, cracks and other damages.
2) Check that the scavenge pump has no cracks, damage or loose part.