Crankshaft Pulley
Crank PulleyREMOVAL
NOTE:
When replacing a single part, perform the work with the engine assembly installed to body.
1) Remove the V-belts.
2) Use the ST to lock the crank pulley, and remove the crank pulley bolt.
ST 499977400 CRANK PULLEY WRENCH (CVT MODEL)
ST 499977100 CRANK PULLEY WRENCH (MT MODEL)
3) Remove the crank pulley.
INSTALLATION
METHOD WITHOUT ANGLE GAUGE
1) Clean the crankshaft thread using compressed air.
2) Install the crank pulley.
3) Apply engine oil to the crank pulley bolt seat and thread.
4) Tighten the crank pulley bolts.
(1) Use the ST to lock the crank pulley, and temporarily tighten the crank pulley bolt.
ST 499977400 CRANK PULLEY WRENCH (CVT MODEL)
ST 499977100 CRANK PULLEY WRENCH (MT MODEL)
Tightening torque:
47 Nm (4.8 kgf-m, 34.7 ft-lb)
(2) Draw reference lines (A) and (B) using a marker to set the socket to the crank pulley bolt as shown in the figure.
NOTE:
Set the socket onto the crank pulley bolt so that reference lines (A) and (B) is visible.
ST 499977400 CRANK PULLEY WRENCH (CVT MODEL)
ST 499977100 CRANK PULLEY WRENCH (MT MODEL)
(3) Draw end line (C) on ST using a marker at the same position as reference line (B) drawn on the socket in step (2).
ST 499977400 CRANK PULLEY WRENCH (CVT MODEL)
ST 499977100 CRANK PULLEY WRENCH (MT MODEL)
(4) Use the ST to lock the crank pulley, and tighten the crank pulley bolt to the angle where reference line (A) and end line (C) are aligned.
NOTE:
It should be approx. 60° when reference line (A) and end line (C) are aligned.
ST 499977400 CRANK PULLEY WRENCH (CVT MODEL)
ST 499977100 CRANK PULLEY WRENCH (MT MODEL)
Tightening angle:
60°±5°
5) Install the V-belts.
METHOD WITH ANGLE GAUGE
1) Clean the crankshaft thread using compressed air.
2) Install the crank pulley.
3) Apply engine oil to the crank pulley bolt seat and thread.
4) Tighten the crank pulley bolts.
(1) Remove the radiator main fan motor assembly and radiator sub fan motor assembly.
(2) Use the ST1 to lock the crank pulley, and temporarily tighten the crank pulley bolt.
ST1 499977400 CRANK PULLEY WRENCH (CVT MODEL)
ST1 499977100 CRANK PULLEY WRENCH (MT MODEL)
Tightening torque:
47 Nm (4.8 kgf-m, 34.7 ft-lb)
(3) Set the ST2, use the ST1 to lock the crank pulley, and tighten the crank pulley bolt to the specified angle.
NOTE:
Attach the magnet used for securing the ST2 (ANGLE GAUGE) to ST1.
ST1 499977400 CRANK PULLEY WRENCH (CVT MODEL)
ST1 499977100 CRANK PULLEY WRENCH (MT MODEL)
ST2 18854AA000 ANGLE GAUGE
Tightening angle:
60°±5°
(4) Install the radiator main fan motor assembly and radiator sub fan motor assembly.
5) Install the V-belts.
INSPECTION
Check that the crank pulley has no deformation, cracks or other damages.