Canister Purge Solenoid: Service and Repair

Purge Control Solenoid Valve

REMOVAL

1. Disconnect the ground cable from battery.






2. Remove the cover (A) and clip (B) from air intake boot assembly.






3. Loosen the clamp (A) which connects the air intake boot assembly and air cleaner case.
4. Loosen the clamp (B) which connects the air intake boot assembly and throttle body.






5. Remove the air intake boot from the throttle body, and move it to the left side wheel apron.






6. Disconnect the purge control solenoid valve connector (A) and evaporation hose (B), and then remove the purge control solenoid valve.
- Other than U5 model






- U5 model






INSTALLATION

Install in the reverse order of removal.

NOTE: Connect the evaporation hose as shown in the figure.

- Other than U5 model






- U5 model






Tightening torque: 6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

- Other than U5 model






- U5 model






NOTE: Align the clamp hole with the protrusion of the air intake boot assembly.






Tightening torque: Clamp (A), (B) 3 N.m (0.3 kgf-m, 2.2 ft-lb)