Rear Gate Latch and Actuator Assembly
Rear Gate Latch and Actuator AssemblyREMOVAL
1. Disconnect the ground cable from battery.
2. Remove the rear gate trim.
3. Remove the rear gate latch & actuator assembly.
1. Remove the bolts and pull out the rear gate latch & actuator assembly to the vehicle front.
2. Disconnect the connectors, and then remove the rear gate latch & actuator assembly.
INSTALLATION
Install each part in the reverse order of removal.
Tightening torque:
T1: 7.5 N.m (0.76 kgf-m, 5.5 ft-lb)
T2: 25 N.m (2.55 kgf-m, 18.4 ft-lb)
T3: 28 N.m (2.86 kgf-m, 20.7 ft-lb)