Evaporative Emission Control Canister: Service and Repair
CanisterREMOVAL
1. Remove the rear wheel LH.
2. Lift up the vehicle.
3. Remove the rear mud guard LH.
4. Disconnect the quick connectors of the vent tube (A), canister drain tube (B) and charge tube (C), and remove the tubes from clips (D).
NOTE: Disconnect the quick connector as shown in the figure.
5. Remove the clip holding the rear wiring harness.
6. Remove the canister from vehicle.
7. Disconnect the connector from drain valve.
8. Disconnect the vent tube (A), canister drain tube (B) and charge tube (C), and remove the canister drain tube (B) from clip (D).
NOTE: Disconnect the quick connector as shown in the figure.
INSTALLATION
1. Install the vent tube (A), canister drain tube (B) and charge tube (C), and install the canister drain tube (B) to clip (D).
CAUTION:
- Make sure there are no damage or dust on connections. If necessary, clean the seal surface of the pipe.
- Make sure that the quick connector is securely connected.
NOTE: Connect the quick connector as shown in the figure.
2. Connect the connector to the drain valve.
3. Install the canister to the vehicle.
Tightening torque: 8 N.m (0.8 kgf-m, 5.9 ft-lb)
4. Secure the rear wiring harness with clip.
5. Attach all tubes to clips (D), and connect the quick connectors of the vent tube (A), canister drain tube (B) and charge tube (C).
CAUTION:
- Make sure there are no damage or dust on connections. If necessary, clean the seal surface of the pipe.
- Make sure that the quick connector is securely connected.
NOTE: Connect the quick connector as shown in the figure.
6. Install the rear mud guard LH.
7. Lower the vehicle.
8. Install the rear wheel LH.
Tightening torque: 120 N.m (12.2 kgf-m, 88.5 ft-lb)