Crankshaft Position Sensor: Service and Repair
Crankshaft Position SensorREMOVAL
1. Remove the collector cover.
NOTE: Follow the steps below when removing the collector cover.
1. Pull up the two points at the rear (A).
2. Pull up the two points at the front (B) while moving them forward.
2. Disconnect the ground cable from battery.
3. Loosen the clamp (A) which connects the air intake boot assembly.
4. Loosen the bolt (B) which secures the air intake boot assembly to the collector cover bracket.
5. Remove the air intake boot assembly, and move it to the left side wheel apron.
6. Remove the throttle body from the intake manifold.
NOTE: Do not disconnect the inlet and outlet hoses of engine coolant.
7. Remove the service hole plug.
8. Remove the crankshaft position sensor.
9. Disconnect the connector from the crankshaft position sensor.
INSTALLATION
Install in the reverse order of removal.
Tightening torque: 6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
Tightening torque:
Clamp (A) 3 N.m (0.3 kgf-m, 2.2 ft-lb)
Bolt (B) 6.5 N.m (0.7 kgf-m, 4.8 ft-lb)
