Cruise Control Switch: Service and Repair

Cruise Control Command Switch

REMOVAL

1. Position the front wheels straight ahead. (After moving a vehicle 5 m (16 ft) or more with front wheels positioned straight ahead, make sure that the vehicle moves straight ahead.)
2. Turn the ignition switch to OFF.
3. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work.
4. Remove the driver's airbag module assembly.

CAUTION: Before handling the airbag module, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM".

1. Using a hexagon wrench etc. wrapped by protective tape, insert the snap pins and release the locks (3 locations).






2. Disconnect the horn harness and airbag connector and remove the airbag module assembly.






Remove the steering wheel.

CAUTION:
- Always use the steering wheel puller for removal to avoid deforming the steering wheel.
- If the steering wheel has been removed, make sure that the roll connector is not turned from the original position.

Preparation tool: Steering wheel puller
1. Disconnect the connector and remove the nut.
2. Put alignment marks and remove the steering wheel using a steering puller.






6. Remove the cruise control command switch.
1. Remove the screw, disconnect the connector and remove the paddle shift switch. (Model with paddle shift)






2. Disconnect the claws and then remove the lower cover.






3. Remove the screw to remove the cruise control command switch assembly.






INSTALLATION

1. Install each part in the reverse order of removal.

CAUTION:
- Before handling the airbag module, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM".
- Do not allow harness and connectors to interfere or get tangled up with other parts.

2. Before installing steering wheel, be sure to adjust the direction of roll connector with steering.

Tightening torque: Steering wheel: 39 N.m (3.98 kgf-m, 28.8 ft-lb)

Clearance: Between column cover and steering wheel: 2 -- 4 mm (0.08 -- 0.16 in)