Installation
Front Hub Unit BearingINSTALLATION
1) Install the front axle housing (a) and front hub unit bearing (c) to the disc brake cover (b) as shown in the figure, and tighten the bolt.
Tightening torque:
65 Nm (6.63 kgf-m, 47.9 ft-lb)
2) Install the front drive shaft.
3) Tighten the axle nut temporarily.
4) Install the disc rotor to hub unit bearing.
5) Install the disc brake caliper to the front axle housing.
Tightening torque:
120 Nm (12.24 kgf-m, 88.5 ft-lb)
6) Install the front ABS wheel speed sensor.
Tightening torque:
7.5 Nm (0.76 kgf-m, 5.5 ft-lb)
7) While pressing the brake pedal, tighten the new axle nuts to the specified torque.
CAUTION:
Do not load the front axle before tightening the axle nut. Doing so may damage the hub bearing.
Tightening torque:
220 Nm (22.43 kgf-m, 162.3 ft-lb)
8) Inspect the lean of axis direction using a dial gauge. Replace the bearing if the load range exceeds the limitation.
Service limit:
Maximum: 0.05 mm (0.0020 in)
9) After tightening the axle nut, lock it securely.
10) Install the wheel.
Tightening torque:
120 Nm (12.24 kgf-m, 88.5 ft-lb)
11) Moving the front tire up and down by hand, check there is no play in bearing, and check the wheel rotates smoothly.
CAUTION:
If there is any fault in the bearing, replace hub unit bearing.
