Entertainment Systems: Service and Repair

Rear Entertainment

REMOVAL
1. Disconnect the ground cable from battery.
2. Insert a flat tip screwdriver in the cutout section, and remove the room light lens.






3. Remove the bolts, and then remove the monitor cover.






4. Remove the 4 mounting bolts.






5. Remove the temporary screws and remove the monitor body.

CAUTION: Pay attention not to drop the body at removal.






6. Remove the temporary clips from the roof brace.

INSTALLATION
1. Align a temporary clip (A) to the protrusion (C) using a temporary screw (B), and attach to the rear entertainment system body.






NOTE: When installing a new rear entertainment system, a clip is supplied on the unit, and step 1) can be omitted.

2. Place the hook of the rear entertainment unit on the roof brace section.
3. Affix the temporary fixture clips on the roof brace.
4. Tighten the 4 attachment bolts, and connect the connector.
5. Connect the room light connector, attach the cover and affix with the bolts.
6. Attach the room light lens from the outside of the vehicle and snap into place.