Tire Monitoring System: Service and Repair
REGISTER TRANSMITTER (ID)Perform the registration procedure of the transmitter in the following cases:
^ Transmitter replaced.
^ TPMS & keyless entry control module replaced.
NOTE:
^ If registration of the transmitter ID is not possible after 2 attempts, replace TPMS & keyless entry control module.
^ If the ignition switch is turned OFF or the Subaru Select Monitor is shut down while registering the transmitter, or if the registration is not performed for 5 minutes or more, the registration mode is cancelled.
^ When rotating tires, there is no affect on the performance or functions of the tire pressure monitoring control module even if the transmitter (ID) is not registered, however, the tire position displayed on the Subaru Select Monitor will be incorrect.
1) Adjust all tire pressures to the specifications.
NOTE:
Refer to the tire caution label on the driver's side door for the correct tire pressure.
2) Connect Subaru Select Monitor and select the {Each System Check} on the <
3) On <
4) After the {Tire pressure monitor} is displayed, select [OK].
5) On <
6) {ID registration mode When execute Registered ID is deleted. Continue?} is displayed, select [OK].
7) Contact the transmitter registration tool to the side wall area near the air valve on the tire, and press the switch. The transmitter ID is sent to the TPMS & keyless entry control module. (At this time, the tire pressure warning light blinks to confirm that the registration has started.)
NOTE:
^ The registration order of transmitter ID is not specified.
^ The transmitter registration tool is used by touching the side wall area near the transmitter.
^ If registration procedure stop in the halfway (turning ignition switch to OFF, wrong registration order, etc), proceed from step 5).
8) When ID registration is completed, the tire pressure warning light remains lit for approximately 2 seconds, to end the registration. Switch to the screen displaying the transmitter ID on the Subaru Select Monitor display.
9) Check the transmitter ID that was registered, then perform a driving test. Scan Tool Testing and Procedures