Automatic Transmission/Transaxle: Adjustments
Select CableADJUSTMENT
1) Shift the select lever to "N" range.
2) Remove the rear exhaust pipe and muffler.
3) Remove the heat shield cover.
4) Loosen the adjusting nuts on both sides.
5) With the select lever pushed towards the rear of the vehicle, turn the adjustment nut B until it just contacts the connector. Then loosen the nut for a half a turn.
6) Set a spanner wrench to adjusting nut B so that it does not rotate, and then tighten the adjusting nut A.
Tightening torque:
7.5 Nm (0.8 kgf-m, 5.5 ft-lb)
7) After the completion of adjustment, confirm that the select lever operates normally at all ranges.
8) Install in the reverse order of removal.