Parking Pawl
Parking PawlREMOVAL
1) Remove the transmission assembly from vehicle body.
2) Remove the extension case.
3) Remove the center differential carrier.
4) Remove the front vehicle speed sensor.
5) Remove the parking support actuator.
6) Remove the parking pawl, parking pawl shaft and return spring.
INSTALLATION
1) Set the transmission to the "N" range.
2) Install the parking pawl, parking pawl shaft and return spring.
3) Install the parking support actuator.
Tightening torque:
10±2 Nm (1.0±0.2 kgf-m, 7.4±1.5 ft-lb)
4) Using the ST, tighten the bolts which tightened in step 3) with specified angle.
Tightening angle:
17°±2°
ST 18854AA000 ANGLE GAUGE
NOTE:
Do not use extension as much as possible.
5) Make sure that the return spring is sticking out of the parking pole hole.
6) Install the front vehicle speed sensor.
7) Install the center differential carrier.
8) Install the extension case.
9) Install the transmission assembly to the vehicle.
INSPECTION
Make sure that the tab of parking pawl on reduction driven gear is not worn or otherwise damaged.