Installation

Select Cable

INSTALLATION

1) Install the select cable to plate assembly.

Tightening torque:
T: 18 Nm (1.8 kgf-m, 13.3 ft-lb)





2) Install the select cable to range select lever.
3) Install the plate assembly to transmission.

Tightening torque:
24.5 Nm (2.5 kgf-m, 18.1 ft-lb)





4) Install the washer and snap pin to range select lever.





5) Install new clamp paying attention to the installing direction.





6) Insert the tip of inner cable into connector hole of select lever, and fix the cable to bracket.





7) Shift the select lever to the "N" range, and then adjust the select cable position. Adjustment
8) Install the heat shield cover.
9) Install the front exhaust pipe, rear exhaust pipe and muffler.