Installation

Select Lever

INSTALLATION

1) Set the select lever to vehicle body.
2) Tighten the four bolts to install the select lever to vehicle body, and then connect the connector.
(1) Temporarily tighten the bolt A.
(2) Tighten the bolt B.
(3) Tighten the bolt A.
(4) Tighten the bolts C and D.

Tightening torque:
18 Nm (1.8 kgf-m, 13.3 ft-lb)





3) Install the shift select cable onto select lever.





4) Install the center console.
5) Install the console box.
6) Shift the select lever to "N" range.
7) Lift up the vehicle.
8) Shift the range select lever to the "N" range.
9) Secure the cable to the bracket.
10) Adjust the select cable position. Adjustment
11) After the completion of adjustment, confirm that the select lever operates properly at all range positions.
12) Install the heat shield cover.
13) Install the rear exhaust pipe and muffler.
14) Inspect the following items. When a malfunction is found in the inspection, adjust the select cable. Adjustment
(1) Engine starts when the select lever is in "P" and "N" range, but not in other ranges.
(2) Back-up light illuminates when the select lever is in the "R" range, but not in other ranges.
(3) Select lever and indicator positions are matched.