Front Wiper Motor and Link
Front Wiper Motor and LinkREMOVAL
1. Disconnect the ground cable from battery.
2. Remove the cowl panel.
3. Remove the bolt, and then remove the wiper assembly.
4. Disconnect the connector of wiper motor assembly.
NOTE: The wiper motor and wiper link is an assembly part and is not to be disassembled.
INSTALLATION
Install in the reverse order of removal.
Tightening torque: Refer to "COMPONENT" of "General Description".
Tightening torque:
T1: 6.0 N.m (0.61 kgf-m, 4.4 ft-lb)
T2: 22 N.m (2.2 kgf-m, 16.2 ft-lb)
T3: 31 N.m (3.2 kgf-m, 22.9 ft-lb)