Installation
Front BumperINSTALLATION
1. Installation of the front bumper cover
1. Connect each connector.
2. Fit in the 7 tabs and install the front bumper cover.
3. Install the clip.
NOTE: Perform same procedures for the RH side.
4. Install the 4 clips.
NOTE: Perform same procedures for the RH side.
5. Install the 7 clips.
6. Install the 2 bolts.
Standard value: T = 7.5 N.m {77 kgf.cm} {5.5ft / lbf}
2. Installation of the front bumper retainer UPR
1. Using the 5 bolts, install the front bumper retainer UPR.
Standard value: T = 7.5 N.m {77 kgf.cm} {5.5ft / lbf}
2. Install the 2 clips.
3. Installation of the side turn signal light ASSY LH
4. Installation of the side turn signal light ASSY RH
NOTE: Install using the same steps as the LH side.
5. Preliminary operation for adjusting the fog light beams (when there are fog lights)
6. Adjusting the fog light beams (when there are fog lights)
7. Inspection of the fog light beams (when there are fog lights)