Assembly
Rear BumperASSEMBLY
1. Installation of the rear bumper bracket CTR (Installed on the LH side)
1. Install the rear bumper bracket CTR.
2. Removal of the rear bumper bracket CTR (Installed on the RH side)
NOTE: Install using the same steps as the LH side.
3. Installation of the rear bumper beam COMPL (rear bumper stay)
1. Using the 4 bolts and the 2 nuts, install the rear bumper beam COMPL (rear bumper stay).
Standard value: T = 45 N.m {459 kgf.cm} {33.2 ft / lbf}
4. Installation of the rear bumper side bracket LH
1. Using 3 screws, install the rear bumper side bracket LH.
5. Installation of the rear bumper side bracket RH
NOTE: Install using the same steps as the LH side.
6. Installation of the rear bumper side retainer LH
1. Using 2 screws, install the rear bumper side retainer LH.
7. Installation of the rear bumper side retainer RH
NOTE: Install using the same steps as the LH side.
8. Installation of the rear bumper side seal LH
1. Using 4 clips, install the rear bumper side seal LH.
9. Installation of the rear bumper side seal RH
NOTE: Install using the same steps as the LH side.
10. Installation of the rear bumper reinforcement NO. 2 (Installed on the LH side)
1. Using 2 clips, install the rear bumper reinforcement NO. 2.
11. Installation of the rear bumper reinforcement NO. 1 (Installed on the RH side)
NOTE: Install using the same steps as the LH side.
12. Installation of the back-up light ASSY