Installation

Rear Bumper

INSTALLATION

1. Installation of the rear bumper cover
1. Preparations for installation
a. Pull the wiring harness of the back-up light ASSY in to the interior.







2. In the direction of the arrow in the figure, insert the 3 guides.







3. Fit in the 5 tabs.

NOTE: Perform same procedures for the RH side.

4. Install the 2 screws.
5. Using 10 clips, install the rear bumper cover.
6. Connect the connector.
7. Using a clamp, install the wiring harness of the back-up light ASSY.

2. Installation of the luggage compartment trim cover INN LH
3. Installation of the luggage compartment side tray
4. Installation of the rear floor finish plate
5. Installation of the luggage compartment floor mat