Removal
Rear BumperREMOVAL
1. Removal of the luggage compartment floor mat
2. Removal of the rear floor finish plate
3. Removal of the luggage compartment side tray
1. Remove the deck floor box LH.
4. Removal of the luggage compartment trim cover INN LH
5. Removal of the rear bumper cover
1. Disconnect the connector of the back-up light ASSY.
2. Release the clamp, and disconnect the wiring harness.
3. Disconnect the grommet, and pull the wiring harness out to the vehicle exterior.
4. Remove the 2 screws.
5. Apply protective tape around the rear bumper cover.
6. Using a clip remover, remove the 6 clips.
7. Using a clip remover, remove the clip.
NOTE: Perform same procedures for the RH side.
8. Pull the rear bumper cover towards the exterior, and release the 5 tabs.
NOTE: Perform same procedures for the RH side.
9. Remove the 3 guides, and remove the rear bumper cover.