Removal
Removal1. Removal of rear tire
2. Removal of propeller shaft with center bearing ASSY
3. Removal of exhaust pipe ASSY FR
4. Removal of differential carrier ASSY RR
5. Removal of rear drive shaft ASSY LH
6. Removal of rear drive shaft ASSY RH
NOTE:
Perform the same procedure as the LH side.
7. Removal of rear axle carrier LH
8. Removal of rear axle carrier RH
NOTE:
Perform the same procedure as the LH side.
9. Removal of fuel tank protector
10. Disconnection of parking brake cable ASSY No. 3
(1) Remove the clamp, and remove the parking brake cable ASSY No. 3.
(2) Remove the bolt, and disconnect the parking brake cable ASSY No. 3 from the rear front support LH.
11. Disconnection of parking brake cable ASSY No. 2
NOTE:
Perform the same procedure as the LH side.
12. Removal of parking brake cable guide (installed on LH side)
13. Removal of parking brake cable guide (installed on RH side)
NOTE:
Perform the same procedure as the LH side.
14. Removal of stabilizer bar RR
15. Removal of rear suspension arm ASSY No. 1 LH
(1) Remove the bolt and nut, and remove the rear suspension arm ASSY No. 1 LH.
16. Removal of rear suspension arm ASSY No. 1 RH
NOTE:
Perform the same procedure as the LH side.
17. Disconnection of rear shock absorber w/ coil spring LH
18. Disconnection of rear shock absorber w/ coil spring RH
NOTE:
Perform the same procedure as the LH side.
19. Removal of rear suspension arm ASSY No. 2 LH
(1) Remove the bolt and nut, and remove the rear suspension arm ASSY No. 2 LH from the rear suspension member SUB-ASSY.
20. Removal of rear suspension arm ASSY No. 2 RH
NOTE:
Perform the same procedure as the LH side.
21. Removal of toe control link SUB-ASSY LH
(1) Mark an alignment mark on the toe adjust plate No. 2 and the rear suspension member.
Captions in illustration
(2) Remove the nut, toe adjust cam, and toe adjust plate No. 2, and remove the toe control link SUB-ASSY LH.
22. Removal of toe control link SUB-ASSY RH
NOTE:
Perform the same procedure as the LH side.
23. Removal of rear suspension member SUB-ASSY
(1) Set a height adjustable attachment, plate lift attachment, etc. on a universal engine lifter, and support the rear suspension member SUB-ASSY.
CAUTION:
^ Using the height adjustable attachment, plate lift attachment, etc., set the rear suspension member SUB-ASSY so that it becomes level.
^ Securely support the rear suspension member SUB-ASSY since it is heavy.
Captions in illustration
(2) Remove the eight bolts, and remove the rear suspension member SUB-ASSY with the front support rear LH, front support rear RH, rear support upper, and rear support lower.
(3) Gradually lower the universal engine lifter, and remove the rear suspension member SUB-ASSY.
CAUTION:
To prevent the rear suspension member SUB-ASSY from tilting greatly or falling, a few operators must support the part when performing the procedure.
24. Removal of upper control arm ASSY RR LH
25. Removal of upper control arm ASSY RR RH
NOTE:
Perform the same procedure as the LH side.
26. Removal of rear differential mount cushion No. 1
27. Removal of rear differential mount cushion No. 2