Installation
Front Seat AssyINSTALLATION
NOTE: The procedures described below are for the LH side. Unless otherwise specified, perform the same procedures for the RH side.
1. Installation of the front seat ASSY LH
1. Return the front seat backrest ASSY to the upright position, and lock it.
2. Carry in the front seat ASSY LH to the vehicle.
CAUTION:
- The front seat ASSY LH must be carried in to the vehicle with the front seat headrest ASSY removed, by more than one personnel.
- Be careful not to damage the front seat ASSY LH, the body exterior and interior.
3. Slide the front seat ASSY LH to the most rear position.
4. Using the torque socket wrench (E10), install the front side of the front seat ASSY LH with 2 bolts.
5. Connect the connectors and the wiring harness clamp.
6. Engage the hook and install the front seat cushion cover LH.
7. Slide the front seat ASSY LH to the most front position.
8. Using the torque socket wrench (E10), install the rear side of the front seat ASSY LH with 2 bolts.
9. Slide the front seat ASSY LH to the most rear position.
10. Using the torque socket wrench (E10), tighten 2 bolts on the front side of the front seat ASSY LH in the order shown in the figure.
Standard value: T = 53 N.m {540 kgf.cm} {39.1 ft.lbf}
11. Slide the front seat ASSY LH to the most front position.
12. Using the torque socket wrench (E10), tighten 2 bolts on the rear side of the front seat ASSY LH in the order shown in the figure.
Standard value: T = 53 N.m {540 kgf.cm} {39.1 ft.lbf}
2. Check of the synchronized locking operation of the slide adjusters
1. Check that the right and left adjusters are simultaneously locked when the seat slides.
2. If the sliders are not synchronized, loosen the bolts securing the seat and adjust them.
3. Installation of the front seat headrest ASSY
4. Connection of the battery ground terminal
Standard value: T = 6.0 N.m {61 kgf.cm} {4.4 ft.lbf}
5. Function inspection of the seat belt
6. Inspection of the airbag warning light
7. Settings when removing/installing the battery terminals