Installation

Installation

NOTE:
The procedures described below are for the LH side. Perform the same procedures for the RH side.

1. Installation of speed sensor RR LH
(1) Install the speed sensor RR LH with 3 bolts.
Standard value:T=7.5Nm {77kgf-cm} {5.5ft-lbf}

CAUTION:
Do not let foreign matter stick to the installation part and the tip of the speed sensor RR LH.

(2) Attach 2 harness clamps.

CAUTION:
Do not attach the harness clamps and the harness bracket with the speed sensor RR LH wire twisted.

(3) Pull the grommet from inside the vehicle and secure it.

CAUTION:
^ Do not pull the wiring harness of the speed sensor RR LH.
^ Do not secure the drilled grommet obliquely.

(4) Connect the connector.
(5) Install the luggage compartment floor mat.
2. Installation of rear tire
Standard value:T=120Nm {1224kgf-cm} {88.5ft-lbf}