Front Brake
RemovalNOTE:
^ The procedures described below are for the LH side.
^ Perform the same procedures both for the LH side and RH side.
1. Removal of front tire
2. Draining of brake fluid
CAUTION:
Do not let brake fluid come into contact with the painted surface. If it happens, wash it out immediately.
3. Disconnection of front flexible hose No.1
(1) Remove a union bolt and 2 gaskets to disconnect the front flexible hose No.1 from the front disk brake cylinder ASSY LH.
4. Removal of front disc brake cylinder ASSY LH
(1) Remove 2 bolts and then remove the front disc brake cylinder ASSY LH.
5. Removal of front disc brake pad (15 inch type)
(1) Remove the disc brake pad from the front disc brake cylinder mounting LH.
(2) Remove the cover (shim) and the shim from each pad.
Captions in illustration
6. Removal of front disc brake pad (16 inch type)
(1) Remove the disc brake pad from the front disc brake cylinder mounting LH.
Captions in illustration
7. Removal of spring (L)
(1) Remove the spring (L) from the front disc brake cylinder mounting LH.
8. Removal of spring (pad)
(1) Remove the spring (pad) from the front disc brake cylinder mounting LH.
9. Removal of front disc brake cylinder slide pin
(1) Remove the front disc brake cylinder slide pin from the front disc brake cylinder mounting LH.
10. Removal of front disc brake cylinder slide pin No.2
(1) Remove the front disc brake cylinder slide pin No.2 from the front disc brake cylinder mounting LH.
11. Removal of boot (pin)
(1) Remove the boot (pin) from the front disc brake cylinder mounting LH.
12. Removal of bushing
(1) Using a thin flat tip screwdriver wrapped with a protective tape, remove the bushing from the pin (B).
Captions in illustration
13. Removal of front disc brake cylinder mounting LH
(1) Remove 2 bolts and then the front disc brake cylinder mounting LH.
14. Removal of front disc
(1) Put alignment marks on the front disc and front axle hub. (It's not necessary when replacing the disc).
Captions in illustration
(2) Remove the front disc.