Rear Brake
RemovalNOTE:
^ The procedures described below are for the LH side.
^ Perform the same procedures for the RH side.
1. Removal of rear tire
2. Draining of brake fluid
CAUTION:
Do not let brake fluid come into contact with the painted surface. If it happens, wash it out immediately.
3. Disconnection of rear left flexible hose
(1) Remove the union bolt and 2 gaskets to disconnect the rear left flexible hose from the disk brake cylinder ASSY RR LH.
Captions in illustration
4. Removal of disc brake cylinder ASSY RR LH
(1) Remove 2 bolts and then the disc brake cylinder ASSY RR LH.
5. Removal of disc brake pad kit RR
(1) Remove the disc brake pad kit RR from the rear disc brake cylinder mounting LH.
Captions in illustration
6. Removal of rear disc brake anti squeal shim kit
(1) Remove the rear disc brake anti-squeal shim kit from the disc brake pad kit RR.
Captions in illustration
7. Removal of pad clip
(1) Remove the pad clip.
8. Removal of rear disc brake cylinder mounting LH
(1) Remove 2 bolts and then the rear disc brake cylinder mounting LH.
9. Removal of rear disc
(1) Put alignment marks on the rear disc and rear axle hub. (This is not required when replacing the rear disc.)
Captions in illustration
(2) Release the parking brake and remove the rear disc.
NOTE:
If it's difficult to remove the rear disc, insert a flat head screwdriver from the rear disc service hole and rotate the adjusting screw to contract the parking brake shoe.
Captions in illustration
10. Removal of parking brake shoe adjusting hole plug
Remove the parking brake shoe adjusting hole plug from the rear disc.
11. Removal of slide pin
(1) Remove the slide pin from the rear disc brake cylinder mounting LH.
12. Removal of slide lock pin
(1) Remove the slide lock pin from the rear disc brake cylinder mounting LH.
(2) Remove the bushing from the slide lock pin.
13. Removal of rear disc brake bushing dust boot
(1) Remove 2 rear disc brake bushing dust boots from the rear disc brake cylinder mounting LH.