Rear Brake
Check1. Disc brake piston and cylinder check
(1) Check that there is no damage on the side of the disc brake piston and on the disc brake cylinder wall.
2. Disc brake pad thickness check
3. Disc thickness check
4. Disc runout check
(1) Before checking the rear disc runout, check the rear axle hub bearing's play and runout.
(2) Secure the rear disc with 5 hub nuts.
Standard value:T=120Nm {1224kgf-cm} {88.5ft-lbf}
(3) Using a dial gauge, check the runout 10 mm{0.394 in} inside of the rear disc's outer periphery.
Captions in illustration
Limit: : 0.05mm {0.002in}
CAUTION:
When the runout exceeds the limit, change the positions of the rear disc and rear axle hub to minimize the runout before installation. If the runout still exceeds the limit even after changing the rear disc and the rear axle hub positions, replace the rear disc with new one.