Disassembly

Disassembly

1. Removal of rear tire





2. Disconnection of rear disc brake caliper ASSY LH
(1) Remove 2 bolts and then disconnect the rear disc brake caliper from the rear axle carrier.

CAUTION:
Hang the brake caliper, using a wire or equivalent.





3. Removal of rear disc
(1) Put alignment marks on the rear disc and the axle hub.

Captions in illustration





(2) Release the parking brake and remove the rear disc.

NOTE:
If it's difficult to remove the rear disc, insert a flat head screwdriver from the rear disc service hole and rotate the adjusting screw to contract the parking brake shoe.





Captions in illustration








4. Removal of parking brake shoe return tension spring No.2 (installed to the front side)
(1) Remove the parking brake shoe return tension spring No.2 (installed to the front side).

Captions in illustration








5. Removal of parking brake shoe return tension spring No.2 (installed to the rear side)
(1) Remove the parking brake shoe return tension spring No.2 (installed to the front side).

Captions in illustration








6. Removal of parking brake shoe strut compression spring
(1) Remove the parking brake shoe strut compression spring.

Captions in illustration








7. Removal of parking brake shoe hold-down compression spring (installed to the front side)
(1) Remove the parking brake shoe hold-down compression spring (installed to the front side).

Captions in illustration





8. Removal of parking brake shoe hold-down spring pin (installed to the front side)
(1) Remove the tension pin (installed to the front side).





9. Removal of parking brake shoe strut LH
(1) Spread the parking brake shoe kit outward with hands and remove the parking brake shoe strut LH.

Captions in illustration








10. Removal of parking brake shoe hold-down compression spring (installed to the rear side)
(1) Remove the parking brake shoe hold-down compression spring (installed to the rear side).

Captions in illustration





11. Removal of parking brake shoe hold-down spring pin (installed to the rear side)

NOTE:
Service the parking brake shoe hold-down spring pin (installed to the rear side) using the same procedures for the parking brake shoe hold-down spring pin (installed to the front side).





12. Removal of parking brake shoe adjusting screw set LH
(1) Spread the parking brake shoe kit outward by hand and pull it out from the lower side of the vehicle.





(2) Remove the parking brake shoe adjusting screw set LH from the parking brake shoe kit.





13. Removal of parking brake shoe kit
(1) Remove the parking brake shoe kit from the parking brake shoe return tension spring No.3.





14. Removal of parking brake shoe return tension spring No.3.
(1) Remove the parking brake shoe return tension spring No.3 from the parking brake shoe kit.





15. Disconnection of parking brake shoe lever LH
(1) Disconnect the parking brake shoe lever LH.





16. Removal of parking brake shoe C type washer
(1) As shown in the figure, spread the parking brake shoe C type washer and remove it from the parking brake shoe kit.
17. Removal of parking brake shoe wave washer
(1) Remove the parking brake shoe wave washer.
18. Removal of parking brake shoe pin
(1) Remove the parking brake shoe pin.