Rear

On-vehicle inspection

NOTE:
^ The following procedure indicates the LH side.
^ For the RH side, perform the same procedure as the LH side.

1. Removal of rear tire
2. Disconnection of rear disc brake caliper ASSY LH
3. Removal of rear disc





4. Inspection of rear axle hub & bearing ASSY axial play
(1) Inspect axial play of the bearing near the axle hub inner periphery (flange portion) using a dial gauge.
Limit: 0.05mm {0.04978mm}

CAUTION:
If it exceeds the limit, replace the rear axle hub & bearing ASSY with a new part.





5. Inspection of rear axle hub & bearing ASSY runout
(1) Inspect runout of the bearing near the axle hub outer periphery using a dial gauge.
Limit: 0.05mm {0.04978mm}

CAUTION:
If it exceeds the limit, replace the rear axle hub & bearing ASSY with a new part.

6. Installation of rear disc
7. Connection of rear disc brake caliper ASSY LH
8. Installation of rear tire
Standard value:T=120Nm {1224kgf-cm} {2,697.48cm-lbf}