Front Suspension Lower Arm

Installation

NOTE:
^ The following servicing procedures are for the LH side.
^ Service the RH side in the same procedure as the LH side.

1. Installation of front suspension lower arm bolt
(1) Using the SST, install a new front suspension lower arm bolt.
SST 20299AG020
Standard value:T=110Nm {1122kgf-cm} {81.1ft-lbf}
2. Temporary tightening of front suspension lower arm ASSY LH
(1) Temporarily tighten the part using the bolt and a new nut.

CAUTION:
Insert the bolt from the front of the vehicle.

3. Installation of steering knuckle LH
With a nut, install the front suspension lower arm ASSY LH to the steering knuckle LH.
Standard value:T=51Nm {520kgf-cm} {37.6ft-lbf}
4. Installation of tie-rod end SUB-ASSY LH
5. Temporary tightening of lower arm support plate
(1) Using a new bolt and nut, install the lower arm support plate.
Standard value:T=110Nm {1122kgf-cm} {81.1ft-lbf}
6. Installation of front tire
Standard value:T=120Nm {1224kgf-cm} {88.5ft-lbf}
7. Stabilization of vehicle
8. Final tightening of front suspension lower arm ASSY LH
(1) Fully tighten the bolts and nuts.
Standard value:T=85Nm {867kgf-cm} {62.7ft-lbf}
9. Installation of undercover front side rear LH
(1) Install the undercover front side rear LH with the three clips.
10. Inspection and adjustment of front wheel alignment
11. Headlight adjustment