A/C - Blower Fan Runs After Being Switched Off
NUMBER: 10-79-13DATE: 02/15/13
APPLICABILITY:
2013 MY BRZ
SUBJECT:
Revised Automatic HVAC Control Panel Assembly
INTRODUCTION
This Bulletin announces a change to the HVAC control panel assembly to address a customer concern of the blower fan continuing to operate after the main control button is switched "OFF".
NOTE:
This information is applicable to vehicles equipped with Automatic Climate Control only.
COUNTERMEASURE IN PRODUCTION
The revised heater control panel assembly was incorporated into production during late July, 2012.
PART INFORMATION
SERVICE PROCEDURE / INFORMATION
Before ordering or replacing the HVAC control panel, ALL of the following parameters must be met:
1. The "recirculate" (center button) must be "ON" (green LED on)
2. Select either "Floor" or "Floor / Defrost" mode with the blower fan operating
3. Vehicle speed must be at least 15MPH
Once parameters 1-3 outlined above have been met, push the "OFF" button. If the blower fan continues to run after pushing the "OFF" button, replace the HVAC control panel assembly.
Follow the service procedure outlined in the applicable Service Manual to complete the repair.
WARRANTY / CLAIM INFORMATION
For vehicles within the Basic New Car Limited Warranty period, refer to Subaru Warranty Wizard for claim submission information.
Disclaimer