Installation
Installation1. Installation of transmission valve body ASSY
(1) Insert the spring and the check ball body into the transmission case.
(2) Make sure that the accumulator piston, spring, and check ball body are installed to the transmission case.
Captions in illustration
NOTE:
If the accumulator piston, spring, and check ball body come off, apply auto fluid WS and install them.
(3) Connect the lever pin to the manual valve hole.
Captions in illustration
(4) Install the transmission valve body ASSY with 19 bolts.
Standard value:T=11Nm {112kgf-cm} {8.1ft-lbf}
NOTE:
Bolt under head length:
^ 25 mm {0.984 in} (Bolt A)
^ 36 mm {1.417 in} (Bolt B)
^ 45 mm {1.772 in} (Bolt C)
^ 50 mm {1.969 in} (Bolt D)
(5) Install the detent spring and detent spring cover with a bolt.
Standard value:T=10Nm {102kgf-cm} {7.4ft-lbf}
2. Transmission wire connection
3. Installation of valve body oil strainer ASSY
4. Installation of transmission oil pan SUB-ASSY (ATM)
5. Installation of exhaust pipe SUB-ASSY FR
6. Connection of battery ground terminal
7. Fill of automatic transmission fluid