Assembly

Assembly





1. Installation of input shaft bearing FR
(1) Use the SST to install the input shaft bearing FR to the input shaft.
SST 499277000, 398477703

CAUTION:
Press-fit by holding the inner race of the input shaft bearing FR.





(2) Select a shaft snap ring so that the thrust clearance between the input shaft bearing FR and the shaft snap ring is within the standard value.
Standard value: 0 mm {0 in}
Limit: 0.1 mm {0.00394 in}

Shaft snap ring type





(3) Install a new shaft snap ring to the input shaft.





2. Installation of synchronizer ring No.2
(1) Apply MG GEAR OIL SPECIAL-II to the synchronizer ring No.2, and install the synchronizer ring No.2 to the input shaft.





3. Installation of needle roller bearing
(1) Apply MG GEAR OIL SPECIAL-II to the needle roller bearing, and install the needle roller bearing to the input shaft.