Seals and Gaskets: Service and Repair

Replacement

1. Drain of transmission gear oil
2. Removal of propeller shaft with center bearing ASSY





3. Removal of transmission extension housing oil seal (MTM)
(1) Use the SST to remove the transmission extension housing oil seal (MTM).
SST 39852770
4. Installation of transmission extension housing oil seal (MTM)
(1) Apply a small amount of MG GEAR OIL SPECIAL-II to the lip of a new transmission extension housing oil seal (MTM).





(2) Use the SST to install the transmission extension housing oil seal (MTM).
SST 09325-20010
Standard value: 0.1 to 1.1 mm {0.00394 to 0.0433 in} (from end face of extension housing)

CAUTION:
^ Avoid damage to the lip of the transmission extension housing oil seal (MTM).
^ Be careful not to install the transmission extension housing oil seal (MTM) in the wrong direction.
^ Do not drive in the transmission extension housing oil seal (MTM) excessively.

5. Installation of propeller shaft with center bearing ASSY

CAUTION:
Thoroughly wipe away the spilled oil.