Installation
Installation1. Installation of clutch start switch ASSY
(1) Install the clutch start switch ASSY to the clutch pedal support SUB-ASSY with the nut.
Standard value:T=8.0Nm {82kgf-cm} {5.9ft-lbf}
(2) Connect the clutch start switch connector.
(3) Measure the gap shown in the figure with the clutch pedal fully depressed.
Captions in illustration
Normal clearance: 3.5 to 4.0 mm {0.138 to 0.157 in}
2. Installation of clutch pedal support SUB-ASSY
3. Installation of clutch switch ASSY
(1) Install the clutch switch ASSY to the clutch pedal support SUB-ASSY with the nut.
Standard value:T=8.0Nm {82kgf-cm} {5.9ft-lbf}
(2) Connect the clutch switch connector.
(3) Check that a gap is not created when the clutch pedal is not depressed.
Captions in illustration
4. Installation of instrument panel under cover SUB-ASSY No.1
5. Installation of instrument side panel LH
6. Check of clutch start system Clutch System