Removal
Front Door Belt MoldingREMOVAL
NOTE: The procedures described below are for the RH side. Unless otherwise specified, the LH side and the RH side follow the same steps.
1. Disconnection of the battery ground terminal
2. Removal of the door arm rest cover RH
3. Removal of the front door trim board SUB-ASSY RH
4. Removal of the power window regulator master switch ASSY W/ front arm rest base panel UPR RH (driver side door)
5. Removal of the power window regulator switch ASSY W/ front arm rest base panel UPR LH (passenger side door)
6. Removal of the front door service hole cover RH (driver side door)
7. Removal of the front door glass weather strip ASSY OUT RH
1. Remove the screw.
2. Using a flat head screw driver wrapped in protective tape, release the tabs, and remove the front door glass weather strip ASSY OUT RH.