Trunk Lid
Trunk LidREMOVAL
1. TORSION BAR
1. Open the trunk lid COMPL.
2. Using the ST, remove the torsion bar - trunk lid.
CAUTION: During removal and installation, handle the torsion bar - trunk lid carefully, because it will generate reactive force.
Preparation tool:
ST: REMOVER (927780000)
1. Remove the torsion bar - trunk lid on the LH side from the hinge link.
2. Remove the torsion bar - trunk lid on the RH side from the hinge link.
2. TRUNK LID PANEL
1. Disconnect the ground cable from battery.
2. Remove the clips, and remove the trim panel - trunk lid.
3. Disconnect the connector to remove the trunk lid harness.
4. Remove the lock assembly - trunk lid.
5. Remove the garnish - trunk.
6. Remove the trunk lid COMPL.
1. Remove the grommet and pull out the trunk lid harness. (RH side only)
2. Remove the left and right bolts, and remove the trunk lid COMPL.
7. Remove the trunk lid arm assembly.
1. Remove the torsion bar - trunk lid from the trunk lid arm.
2. Remove the trim panel assembly - rear shelf.
3. Remove the bolts, then remove the trunk lid arm assembly.
INSTALLATION
1. Install each part in the reverse order of removal.
2. Apply grease to the rotating area of hinges.
3. Install while paying attention to make a uniform clearance around the trunk lid COMPL.
Tightening torque:
Refer to "COMPONENT" of "General Description". [Ref. to TRUNK LID PANEL, COMPONENT, General Description.]