Installation

Rear Sub Frame

INSTALLATION

CAUTION:
^ Be sure to use a new self-locking nut.
^ Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.

1) Check the removed parts for wear, damage and crack, and repair or replace them if faulty.
2) Install each part in the reverse order of removal.

Tightening torque:
Refer to "COMPONENT" of "General Description" for the tightening torque.

3) Bleed air from brake system.
4) Install the rear wheels.

Tightening torque:
120 Nm (12.24 kgf-m, 88.5 ft-lb)
5) Inspect the wheel alignment and adjust if necessary.
^ Inspection: Service and Repair

CAUTION:
When the wheel alignment has been adjusted, perform "VDC sensor midpoint setting mode" of the VDC.

6) Connect the battery ground terminal.
7) Perform reinitialization of the auto headlight beam leveler system. (model with auto headlight beam leveler)