Removal and Replacement

Sunroof Assembly







REMOVAL

CAUTION: When removing the clip, use great care not to damage the trim panel - roof assembly.

1. Remove the lid assembly - sunroof.
1. Completely close the lid assembly - sunroof, and open the sunshade assembly.
2. Remove the TORX(R) bolt, and then remove the lid assembly - sunroof.

CAUTION: Be careful not to damage the lid assembly - sunroof.

PREPARATION TOOL:
TORX(R) T25







2. Remove the trim panel - roof assembly.
3. Disconnect the harness connector of the motor assembly.
4. Remove the rail assembly.
1. Remove the drain tube - sunroof.







2. Remove the bracket - assist rail.







3. Remove the bolts and then remove the sunroof bracket.







4. Remove the bolts, then remove the rail assembly.







INSTALLATION

CAUTION: Be careful not to snag the harness.

Install each part in the reverse order of removal.

Tightening torque:
Refer to "COMPONENT" of "General Description". [Ref. to COMPONENT, General Description.]

NOTE:
- Be sure to connect the harness connector.
- When installing the drain tube - sunroof, insert it securely into drain pipe.

Length A:
15 mm (0.59 in) or more