Traction Control Switch: Service and Repair

VDC OFF Switch

REMOVAL

1) Remove the cover assembly - instrument panel LWR driver.

CAUTION:
When removing the cover assembly - instrument panel LWR driver, be sure to pull it toward you. If attempting to remove by turning it upward, the claws may be damaged.





(1) Remove the clips, and remove the cover - instrument panel side LH.





NOTE:
Using a plastic remover, open the cover - instrument panel side LH.
(2) Remove the screws and release the clips and claws.
(3) Disconnect the harness connectors, and remove the cover assembly - instrument panel LWR driver OUT.





2) Remove the screws and release the claws, then detach the cover.





3) Release the claws and remove the VDC OFF switch.





INSTALLATION

Install each part in the reverse order of removal.

INSPECTION

1) Disconnect the VDC OFF switch connector.
2) Check the resistance between the VDC OFF switch terminals.

PREPARATION TOOL:
Circuit tester





3) Replace the VDC OFF switch if the inspection result is not within the standard value.