Installation

Steering Column

INSTALLATION

CAUTION:
If the steering wheel and steering angle sensor are removed, perform "VDC sensor midpoint setting mode" of the VDC.

1) Install the grommet to the toe board.





2) Insert the end of the column assembly - steering into the toe board grommet.
3) Tighten the column assembly - steering installation bolt located under the beam COMPL - steering with the tilt lever fixed.

Tightening torque:
20 Nm (2.04 kgf-m, 14.8 ft-lb)

4) Connect all connectors located under the beam COMPL - steering.
5) Connect the horn harness and airbag connector, and install the airbag module.
6) Install the knee airbag module.
7) Install the cover assembly - instrument panel LWR driver INN and OUT.
8) Install the universal joint assembly - steering.

CAUTION:
^ Always install the universal joint assembly - steering after installing the steering column to avoid damage to the universal joint assembly - steering.
^ Be sure to follow the tightening order and tightening torque of the universal joint assembly - steering to avoid the steering effort from becoming heavy.
9) Align the center position of the steering roll connector.
10) Install the steering wheel.