Operation

Subaru Select Monitor

OPERATION

HOW TO USE SUBARU SELECT MONITOR

1) Prepare the Subaru Select Monitor kit.





2) Prepare PC with Subaru Select Monitor installed.
3) Connect the USB cable to SDI (Subaru Diagnosis Interface) and USB port on the personal computer (dedicated port for the Subaru Select Monitor).

NOTE:
The dedicated port for the Subaru Select Monitor means the USB port which was used to install the Subaru Select Monitor.

4) Connect the diagnosis cable to SDI.
5) Connect SDI to data link connector located in the lower portion of the instrument panel (on the driver's side).





CAUTION:
Do not connect scan tools other than the Subaru Select Monitor.

6) Start the PC.
7) Turn the ignition switch to ON (engine OFF) and run the "PC application for Subaru Select Monitor".
8) Record the DTC and data.

NOTE:
For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".

9) If the power steering control module and Subaru
Select Monitor can not communicate, check the communication circuit. Inspection

READ CURRENT DATA

1) On [[Main Menu]] display, select {Each System Check}.
2) On [[System Selection Menu]] display, select {Power Steering System}.
3) On [[Power Steering Diagnosis]] display, select {Current Data Display & Save}.
4) Using the scroll key, scroll the display screen up or down until the desired data is shown. The list is indicated in the following table.





NOTE:
^ *1 When the value exceeds the maximum of 250 times, 250 is displayed.
^ *2 When there is no intervention of the overheating protection control, "65535" is displayed. If an error such as control unit memory error, etc. occurs, "65534" is displayed.

FREEZE FRAME DATA

NOTE:
^ Freeze frame data stored at the time of trouble occurrence is shown on the display.
^ Each time a trouble occurs, the latest information is stored in the freeze frame data in memory.
^ One freeze frame data will be stored.