Installation
Rear Hub Unit BearingINSTALLATION
1) Place the back plate - rear brake between the housing assembly - rear axle and the hub unit COMPL - rear axle, and tighten the bolt.
CAUTION:
^ Be careful not to damage the magnetic encoder.
^ Do not get closer the tool which charged magnetism to magnetic encoder.
Tightening torque:
65 Nm (6.63 kgf-m, 47.9 ft-lb)
2) Install the rear axle shaft assembly.
CAUTION:
^ Do not tap the axle shaft using a hammer when installing axle shaft assembly.
^ Use new nut - axle.
(1) Insert the axle shaft assembly into the hub spline, and pull in the axle shaft assembly into specified position.
(2) Temporarily tighten the nut - axle.
3) Install the disc rotor to the hub unit COMPL - rear axle.
4) Install the caliper body assembly to the housing assembly - rear axle.
Tightening torque:
66 Nm (6.73 kgf-m, 48.7 ft-lb)
5) Install the rear ABS wheel speed sensor.
Tightening torque:
7.5 Nm (0.76 kgf-m, 5.5 ft-lb)
6) While depressing the brake pedal, tighten new nuts - axle to the specified torque.
CAUTION:
Do not load the rear axle before tightening the nut - axle. Doing so may damage the hub unit COMPL.
Tightening torque:
190 Nm (19.37 kgf-m, 140.1 ft-lb)
7) Inspect the lean of axis direction using a dial gauge. Replace the hub unit COMPL - rear axle if the play exceeds the limit.
Service limit:
Maximum: 0.05 mm (0.0020 in)
8) After tightening the nut - axle, lock it securely.
9) Install the rear wheels, and perform the following inspections.
Tightening torque:
120 Nm (12.24 kgf-m, 88.5 ft-lb)
1. Check the wheels for smooth rotation.
2. Check that there is no play by moving the upper and lower portions of rear tire in an axial direction with the brake pedal released.
^ Play exists -> Check the hub unit COMPL - rear axle. Rear Hub Unit Bearing