Disassembly

Select Lever

DISASSEMBLY

GRIP ASSY

1) Remove the button assembly_AT.





2) Remove the rod COMPL.

AT SELECT LEVER ASSEMBLY

1) Remove the spacer plate.





2) Remove the gasket.





3) Insert a flat tip screwdriver with a thin tip under the connector and disconnect the harness connector from the plate COMPL.





4) Remove the harness from the plate COMPL.





5) Raise the claw with a flat tip screwdriver with a thin tip and remove the solenoid unit.





6) Using a flat tip screwdriver with a thin tip, remove the solenoid unit terminals from the connector.





7) Remove the clamp push nut.

NOTE:
Replace the clamp push nut with a new part.





8) Pull out shaft control.





9) Remove the clamp push nut.

NOTE:
Replace the clamp push nut with a new part.





10) Pull out spacer pin guide.





11) Remove the clamp pin.





12) Remove the spacer pin guide.





13) Remove the select lever COMPL from the plate COMPL.





14) Remove the arm COMPL.





15) Remove the plate guide from the select lever COMPL.





16) Remove the rod detent and detent spring from the select lever COMPL.