Assembly

MT Gear Shift Lever

ASSEMBLY

NOTE:
^ Clean all the parts before assembly.
^ Apply NIGTIGHT LYW No. 2 grease or equivalent to each part.

1) Mount the bushing and cushion rubber to the stay.





2) Install the bushing and spacer to boss.





3) Install the boss to the joint.

NOTE:
Use a new self-locking nut.

Tightening torque:
12 Nm (1.2 kgf-m, 8.9 ft-lb)





4) Install the snap ring to gear shift lever and install the bushing.

NOTE:
Apply grease to the bushing.





5) Apply grease to the bushing and O-ring, and then install to gear shift lever.





6) Apply sufficient grease into boss, and then install the gear shift lever to the stay.





7) Install the snap ring.





8) Insert the gear shift lever and rod into boot hole.
9) Install the rod.

NOTE:
Use a new self-locking nut.

Tightening torque:
12 Nm (1.2 kgf-m, 8.9 ft-lb)





10) Install the lock wire.

NOTE:
Use a new lock wire.





NOTE:
^ Install the lock wire to the stay groove.
^ Bend the extra wire to the same direction of lock wire winding.