Rear Door Window Glass: Service and Repair

Rear Door Glass







REMOVAL

1. Remove the trim panel - rear door.
2. Remove the sealing cover - rear door.

CAUTION:
- Carefully remove the butyl tape. Excessive force will easily break the sealing cover - rear door.
- If the sealing cover - rear door gets broken, replace it with a new part.

1. Remove the screw to remove the bracket - door trim rear.
2. Carefully remove the butyl tape to remove the sealing cover - rear door.







3. Attach the battery ground cable and the switch - power window, and turn the ignition to ON.
4. Remove the glass assembly - rear door.
1. Operate the switch - power window sub rear to move the glass assembly - rear door to the lowest position.
2. Remove the screws and bolts, and then remove the sash COMPL - rear partition.







3. Remove the glass - rear door partition.







4. While tilting the glass assembly - rear door, remove the guide from the roller of the regulator and motor assembly - rear, then remove the glass assembly - rear door.

CAUTION: Avoid impact and damage to the glass assembly - rear door.







INSTALLATION

CAUTION: Check that the running channel - rear door is securely fixed to the panel assembly - rear door and to the sash COMPL - rear partition.

Install each part in the reverse order of removal.

Tightening torque:
Refer to "COMPONENT" of "General Description". [Ref. to REAR DOOR GLASS, COMPONENT, General Description.]