Front Seat
Front SeatFRONT SEAT LH
FRONT SEAT RH
REMOVAL
CAUTION: The airbag system is fitted with a backup power supply. After disconnecting the battery ground cable, the airbag may operate if you do not wait for 60 seconds before starting the service of airbag system.
1. DRIVER'S SEAT
1. Disconnect the ground cable from battery, and wait for 60 seconds or more before starting work.
2. Remove the slide rail installing bolt.
1. Tilt the backrest forward and move the seat to the front most position.
2. Remove the rear bolt cover at the rear side of the slide rail and remove the bolt.
3. Move the seat to the rearmost position, and remove the bolt on the front side of the slide rail.
3. Disconnect the connector under the seat.
CAUTION: Disconnect the ground cable from battery, and wait 60 seconds before disconnecting the connector.
- Seat belt buckle switch connector
- Side airbag connector
- Seat heater connector (model with seat heater)
4. Remove the front seat from vehicle.
2. PASSENGER'S SEAT
CAUTION: Refer to "CAUTION" of "General Description" for "AIRBAG SYSTEM" section before starting the work.
1. Disconnect the ground cable from battery, and wait for 60 seconds or more before starting work.
2. Tilt the backrest forward, and move the seat forward.
3. Remove the rear bolt cover, and then remove the rear side of slide rail.
4. Move the seat backward, remove the front bolt cover, and then remove the bolt at the front side of slide rail.
5. Disconnect all the connectors of connector holder in the backside of seat cushion.
- Harness connector of occupant detection control module
- Side airbag connector
- Seat heater connector (model with seat heater)
6. Remove the seat from vehicle.
INSTALLATION
Install each part in the reverse order of removal.
NOTE: Tighten the slide rail installing bolt gradually in several steps to the specified torque in the order as shown in the figure.
Tightening torque:
Refer to "COMPONENT" of "General Description". [Ref. to FRONT SEAT LH, COMPONENT, General Description.]