Assembly
MT Gear Shift LeverASSEMBLY
NOTE:
^ Clean all the parts before assembly.
^ Apply NIGTIGHT LYW No. 2 grease or equivalent to each part.
STI MODEL
1) Mount the bushing and cushion rubber to the stay.
2) Install the bushing and spacer to boss.
3) Install the snap ring to gear shift lever and install the bushing.
NOTE:
Apply grease to the bushing.
4) Apply grease to the bushing and O-ring, and then install to gear shift lever.
5) Apply sufficient grease into boss, and then install the gear shift lever to the stay.
6) Install the snap ring.
7) Insert the gear shift lever and rod into boot hole.
8) Install the rod.
Tightening torque:
12 Nm (1.2 kgf-m, 8.9 ft-lb)
9) Install the boss to the rod.
Tightening torque:
12 Nm (1.2 kgf-m, 8.9 ft-lb)
10) Install a new lock wire.
NOTE:
^ Install the lock wire to the stay groove.
^ Bend the extra wire to the same direction of lock wire winding.
11) Install the holder.
Tightening torque:
1.3 Nm (0.1 kgf-m, 1.0 ft-lb)
12) Insert the reverse check cable into the boot hole.
13) Insert the reverse check cable into the gear shift assembly, and fix in place with a band clip.
NOTE:
^ Cut the excess band clip.
^ Make sure that the reverse check cable is inserted into the gearshift lever with no gaps.
14) Install the seat cushion and spring.
15) Use the spring pin to secure the end of the slider and reverse check cable.
NOTE:
Apply grease to the moving part of slider.
16) With the cable pulled (the slider is lowered), adjust the distance between the edge of cable plate and the reverse check cable to 84 mm (3.31 in), and tighten the lock nut.
Tightening torque:
6 Nm (0.6 kgf-m, 4.4 ft-lb)
17) Secure the reverse check cable to the stay clip.
NOTE:
Install the reverse check cable on top of the stay.
EXCEPT FOR STI MODEL
NOTE:
^ Clean all the parts before assembly.
^ Apply NIGTIGHT LYW No. 2 grease or equivalent to each part.
1) Mount the bushing and cushion rubber to the stay.
2) Install the bushing and spacer to boss.
3) Using new self-locking nuts, install the boss to the joint.
Tightening torque:
12 Nm (1.2 kgf-m, 8.9 ft-lb)
4) Install the snap ring to gear shift lever and install the bushing.
NOTE:
Apply grease to the bushing.
5) Apply grease to the bushing and O-ring, and then install to gear shift lever.
6) Apply sufficient grease into boss, and then install the gear shift lever to the stay.
7) Install the snap ring.
8) Insert the gear shift lever and rod into boot hole.
9) Install the rod.
Tightening torque:
12 Nm (1.2 kgf-m, 8.9 ft-lb)
10) Install a new lock wire.
NOTE:
^ Install the lock wire to the stay groove.
^ Bend the extra wire to the same direction of lock wire winding.
