Disassembly
MT Gear Shift LeverDISASSEMBLY
STI MODEL
1) Remove the spring pin from the slider.
2) Remove the slider and spring.
3) Cut off the band clip.
4) Remove the reverse check cable from the cable plate.
5) Remove the reverse check cable from the gear shift assembly.
6) Remove the holder and spring.
7) Disassemble the lock wire.
NOTE:
Do not reuse the lock wire.
8) Remove the boss from the rod.
9) Remove the rod from lever.
10) Separate the rod and inner boot.
11) Remove the snap ring from the stay.
12) Separate the gear shift lever and the stay.
13) Remove the O-ring and bushing from the gear shift lever.
14) Remove the spring pin, and then remove the bushing and snap ring.
15) Remove the bushing and spacer from the boss.
16) Remove the bushing and cushion rubber from the stay.
EXCEPT FOR STI MODEL
1) Remove the lock wires.
2) Remove the rod from lever.
3) Separate the rod and inner boot.
4) Remove the snap ring from the stay.
5) Separate the gear shift lever and the stay.
6) Remove the O-ring and bushing from the gear shift lever.
7) Remove the spring pin, and then remove the bushing and snap ring.
8) Remove the boss from the joint.
9) Remove the bushing and spacer from the boss.
10) Remove the bushing and cushion rubber from the stay.
