Clearing Diagnostic Trouble Codes

Subaru Select Monitor

Clear Memory Mode

OPERATION

1) Place the shift lever in neutral.
2) Using the Subaru Select Monitor, on the [[Main Menu]] display, select {Each System Check}.
3) On [[System Selection Menu]] display, select {Transmission Control System}.
4) After the {Center Differential Control} is displayed, select [OK].
5) On [[Transmission Diagnosis]] display, select {Clear Memory}.
6) When "Done. Turn off the ignition switch." is displayed, select [OK].
7) Turn the Subaru Select Monitor and ignition switch to OFF. To turn the ignition switch to ON again, wait for 10 seconds or more.

NOTE:
^ To clear the previous DTC, use {Clear Memory}.
^ For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".