Read Current Data
Subaru Select MonitorRead Current Data
OPERATION
1) Using the Subaru Select Monitor, on the [[Main Menu]] display, select [Each System Check].
2) On [[System Selection Menu]] display, select [Transmission Control System].
3) After the [Center Differential Control] is displayed, select [OK].
4) On [[Transmission Diagnosis]] display, select [Current Data Display & Save].
5) Select [Normal sampling] on the [[Current Data Display & Save]] screen.
6) Using the scroll key, scroll the display screen up or down until the desired data is shown.
^ A list of the support data is shown in the following table.
*1 : Displayed by the number
0 in the manual mode
1 in AUTO[-] / 2 in AUTO / 3 in AUTO[+]
*2 : Displayed by the number
0 in AUTO mode
1 (Free), 2, 3, 4, 5, 6 (LOCK) in manual mode
NOTE:
For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".